REVIEW-27: SDIACT-174 Implement Genesis II WS-STS interface to Nexus identities and groups - Test Readiness Review

This is a test readiness review for SDIACT-174, which enables GFFS grid logins via Globus Auth authentication.

Software:

• http://software.xsede.org/development/genesis2/sdiact-174/production_grid/

Documentation

• Introduction
  • XSEDE GFFS Quickstart guide
• Design/Security overview
  • Security and General Design Description
• Installation guide
  • SDIACT-174 Installation Guide (see "XSEDE Service Provider Client Install" instructions.)
• Deployment Plan
  • SDIACT-174 Deployment Plan
• User guide
  • GFFS User guide (see Section E) (no user changes)
• Defect, issue, and risk reporting
  • See SDIACT-174 test plan below
• Acceptance test plan
  • Test Plan
• Testing resources
  • hpcdev-pub-04.sdsc.edu (CentOS 6)

Package information: All software packages (e.g., server and client packages) for this CI are listed.

Documentation and Installation instructions: The deployment plan for this CI on XSEDE is clearly described as well as the installation instructions and any XSEDE specific configuration instructions.

Test environment and facilities: The test environment needed to adequately to validate this component is described. Should indicate also whether testing can be performed within a VM and if not, the reasons for it.

Assumptions: Lists any assumptions needed before testing can begin (e.g., accounts needed).

Test procedures, cases, and scenarios: Lists the tests that should be run or an associated test suite and expected performance metrics if applicable.

Defect, issue, and risk reporting: Deployment plans should include defect and issue reporting information. The testing plan could reference that same information from the deployment plan, or provide alternate information if defects and issues need to be reported differently during testing. Risks, as well as defects and issues, should be part of the testing report.